Standard combination of cross-flow square tower

Standard combination of cross-flow square tower

Standard cross-flow tower

FHGL series cross-flow fiberglass cooling tower with both sides into the wind, by the top of the fan, the air through the tower on both sides of the filler, and hot water for medium exchange, hot and humid air and then discharged to the tower. Filler using the bump on both sides of the wave plate, through the installation of the first spot wave plate bonded to the whole, in order to improve the rigidity of the bumps on both sides but also to avoid direct drip, thus increasing the water film formation capacity, Water measures.

Product Features:
1, save space, light weight structure
Using a series of cooling towers designed specifically for efficient heat exchange packing, the heat transfer area increased significantly, with the original HBLD series and the original HBLCD series, the area has dropped significantly, due to structural optimization and the use of steel structure , Operating weight is greatly reduced.
2, save electricity
Adopt the packing with small ventilation resistance and the airfoil type FRP fan designed by Tsinghua University for the cooling tower to reduce the power of the motor. The ultra-low noise type uses smaller motor power and saves power. According to the user''s request, equipped with two-speed motor to save power.
3, operating noise is very low
Cooling tower operation noise is reduced with Tsinghua University''s low-noise FRP airfoil fan designed specifically for cooling towers and a low-noise motor designed specifically for cooling towers. Ultra-low noise cooling towers operate at lower noise levels and fully comply with environmental requirements. If equipped with two-speed motor, low-speed operation at night, but also to reduce the noise 2-3dB (A), the user needs two-speed motor should be ordered separately when the request.
4, good corrosion resistance
Tower body, sink and panel are made of FRP material with good corrosion resistance, and add a light stabilizer in the gel coat resin, with good anti-aging properties, durable color. Tower body steel structure after processing galvanized, improve the corrosion resistance of the cooling tower, in the normal service life, without additional corrosion.
5, a combination of convenience
Can be combined to meet the requirements of different conditions, the user can also determine the combination of site conditions, and according to the characteristics of the user''s building, adjust the appearance of the cooling tower. Such as user space is very limited. My company can also be designed for the special requirements of users to meet the user''s thermal performance and noise requirements.
6, easy maintenance
This series of cooling towers are combined design, adjacent to the cooling tower air room separated from each other, the cooling tower in the normal operation of the premise, for maintenance, cleaning filler, water pipes and water tank work more convenient.